Home > Knowledge > Content
Automatic glove machine common fault problem solution?
Feb 26, 2018

1. Automatic glove machine is always broken?

A) one is the quality of the line, if the best cotton thread to the line of oil, is to find out if there is no place to hang

B) Check the yarn feeder, sinker, hook and other related parts for any problems.

2. automatic automatic glove machine and chain automatic glove machine What is the difference?

The chain machine is a generation machine, the computer machines are more than two generations of machines, advanced computer, high output, good output good quality gloves, and very few chain mechanic, the machine is not good to find someone repair, computer In the market accounted for more than 95%.

3 automatic fully automatic glove machine 7-pin. 10-pin. Thirteen needles What is the difference.

A few needle machine refers to a few needles per inch, such as the number of seven needles needle less dense needle large, so rough cotton yarn. Thirteen needle needle needle is a small cotton yarn, coarse cotton can not do.

4. Automatic glove machine maintenance before the pin does not turn round is how?

Probably the needle plate is wrong, or needle roller pull spring out. You just need to make some adjustments.

5. Strike pin: Strike pin is a kind of trouble which often occurs in braiding machine. Though it is seldom heard by layman, it will have an important influence on the use of machine. Therefore, the striker should be avoided during use. Woven gloves are now in use in our lives is very much, and the production of its gloves knitting machine is being used by the manufacturers. In the weaving process of this glove, it often happens that the butt of the knitting needle collides with each knitting cam to cause a mechanical failure, which is what we call the firing pin. For such a fault, the glove weaving machine is very vulnerable to damage, so it has already appeared immediately resolved, so as to avoid mechanical damage too much. Therefore, the use of gloves knitting machine manufacturers must always check the mechanical inspection, maintenance or understanding of the solution to the breakdown of the pin solution, so as to be able to well avoid the occurrence of firing pin failure.

6. Broken on the hook line: a lot of cotton gloves manufacturers will encounter on the bending needle often cut off the fault, there are two main reasons for this failure, one is the wrong suture or under the looper line clamp pressure Large, failure caused by this reason should pay attention to the threading of securities or loosen some clamp nut on the looper thread. The second reason is that the upper looper needle eye hair, if this is the reason, it should be coated with a string of polishing paste, into the upper looper needle eye pull. Or simply change a looper on it.


Products List